How To Properly Clean Up After A Kitchen Grease Fire
The smoke point of an oil has to do with how refined it is, with more refined oils having higher smoke points. The three common cooking oils with the highest smoke points are peanut oil, safflower oil, and soybean oil, which all have smoke points of approximately 450°F. Be aware that approximate really does mean approximate, as any one oil may start to smoke at a little higher or lower temperature. It would be difficult to give accurate autoignition points for all cooking oils, but expect between 400 to 435°C (750 to 815°F), and you’ll be in the ballpark. The heat, which slowly builds up from the bacteria metabolizing, must be confined within the heap of hay, straw, or compost, and unable to escape, so that it causes the material inside to reach its autoignition temperature, at which point it spontaneously bursts into flames. As soon as the flames spread over the pan, I picked up a fire extinguisher and, working as quickly as I could, figured out how to use it and shot it toward the flaming pan.
Have the oven inspected and repaired before you use it again. Oven fires. Immediately close the oven door and turn it off. Turn off the burner and leave the pan exactly where it is so that it can cool. If this occurs, turn off the heat completely and allow the oil to cool down to below boiling. Never move the pan, never carry it outside or put it in the sink, and don’t lift the lid until the pan has turned cool. Whenever you’re cooking, have an oven mitt, a potholder, and a lid that fits your pan all on hand and ready to grab in case fire sparks. If grease catches on fire in your cooking pan, quickly put on the oven mitt, then place the lid over the pan to smother the fire. Next, read about how to put out an electrical fire in five steps. No matter whether you know some basic steps for putting out a small fire there is absolutely no guarantee that you will be able to successfully put out a fire in your home. ♦ When you take the chandelier apart be sure to keep track of how to put it back together.
If you have ever seen or experienced the phenomenon of a grease fire being put out, and then spontaneously bursting back into flames a moment later, this is the reason. Most authors on the internet seem to assume that the smoke point of an oil is the same as the ignition point, that is, that when an oil smokes, it is just about to burst into flames. Turn off the AC during the cleaning process in order to prevent soot and smoke odor particles from spreading into other rooms. When you turn off an electric stove, of course, the burner remains hot for a while, so you are not really immediately removing the heat source. However, once an oil has reached its smoke point, it is definitely time to turn down the heat, as the oil is becoming too hot! They probably thought the hand of God had reached down and started their hay on fire. This means that re-ignition may occur after the flames have been extinguished, unless the oil is cooled down to below the new autoignition temperature. It comes down to the operator and properly maintaining your pellet grill.
So the reward will be there when it comes to task doing. Now, comes the fire point. The fire point is the temperature that must be reached for the vapor to continue to burn after being ignited, even if the ignition source is removed. On a gas stove, once the flame is off, it is possible for an oil that has reached the flame point, but not fire point, to go out. Here is the weird part: Once a Vegetable oil has reached its flash point, and has ignited, it is possible for the autoignition temperature to become lower. Although smoking oil should be enough of a warning to you, when an oil reaches its boiling point, it is getting very close to auto-igniting. Water is extremely dangerous in such situations as it can conduct electricity and there is a potential of getting an electric shock or even being electrocuted. The cut-off point between a flammable and combustible liquid is usually considered a flash point of 100°F (38°C), with anything under this being a flammable. The flashpoint, in fact, is used as a dividing line between when a liquid is considered flammable or combustible. Cold season can cause a big problem in your pipes and water line.